This versatile addition to the Wayfinder range takes the place of both our 76 mm and 100 mm round posts, thanks to its capabilities for strengthening with off the shelf aluminium flat bar or rectangular hollow section (depending on required strength).
   Panels are retained in a new accompanying extrusion which when flipped round is used as an infill to the post slots on areas without panels. The panels themselves no longer require fabrication as any 6 mm thick panel can be used, be it aluminium, foamex, acrylic or timber. Face panels can now be very easily CNC cut to allow features such as arched or apex tops etc.
   Another capability of this new extrusion is that there is a second post slot available. As the vast majority of post and panel signs are of the typical two post configuration, the second slot has been designed to be routered open as required. This allows construction of triple (or more) post signs.
   This whole concept of this new post was that the majority of post and panel signs are quite small, and therefore some post systems are over-designed, adding unnecessary cost. Our system works in reverse, where we can design upwards as required.

Scaled cross-section illustrations in Adobe Acrobat .pdf format can be downloaded by choosing your variation below and clicking the thumbnail. If you require software to allow you to view .pdf files, click on the "get Acrobat Reader" icon to the right to download Acrobat Reader, free of charge.
   Please note that to print these scaled illustrations from Acrobat Reader properly, with the scale ratio remaining intact, you must make sure that the Page Scaling (or Fit to Page) option is set to None in the print dialog box.